Manual

DescriptionItem
O-Ring1
#6 Cap Screw2
300 and 600 kip (1300 and 2600 kN) Force Transducers
DescriptionItem
O-Ring1
#4 Cap Screw2
2.
Danger:
The next step puts your hand in a crush zone.
Hands can be crushed and equipment can be damaged equipment when hydraulics are
turned on.
Make sure you have turned off load unit hydraulic pressure and locked the bell up in place.
Disconnect the force transducer’s cable at its feedthrough connection.
3. Screw the puller’s two cap screws into the insert’s threaded holes. Then use the thumbscrews to pull
the insert out.
Triaxial Cell Product Information | 77
Operation