Owner manual

Set up a Scope to compare the command signal to the resulting feedback. Enlarge the scope if
necessary, and then set up the scope as follows:
Y1 parameters:
• Channel — Ch1 (or other depending on your configuration)
• Signal — Command
• Unit — kN
• Units/div — 0.1000
• Offset — 0.3000
Y2 parameters:
• Channel — Ch1 (or other depending on your configuration)
• Signal — Force
• Unit — kN
• Units/div — 0.1000
• Offset — 0.3000
Time:
• Trace Time — 5.0000 s
5. Set the HPU and HSM to Power High.
94 | MTS TestLine Test System Operation
Running the Example HCF Test