Owner's manual

SWIFT 50 GLP Sensors Installation

Road Simulator

Installing the Transducer

Equipment required This procedure requires one person. To install the transducer, you will need the

following equipment:

• Spindle adapter spacers (see next figure)

• Adapter to 329 simulator

• Anti-rotate assembly (including customer-supplied mounting arm)

• Small set of metric hex-head wrenches

• Tube bender for the restraint tube

• Tube cutter

• Metric socket head drive set (up to 14 mm) with extension

• Molykote g-n paste, 2.8 oz. tube (MTS part number 011-010-217)

• Nikal based anti-galling compound (MTS part number 011-354-902)

• Transducer mounting bolts (per transducer)

For dual rims

16 size M16 X 1.5 mm

8 size M10 X 1.5 mm

4 size M5 X 0.8 mm

lug nuts and shim washers

For front rims

16 size M16 X 1.5 mm

8 size M10 X 1.5 mm

4 size M5 X 0.8 mm

lug nuts and shim washers

• For dual rims

Slip ring extension assembly

Four size M12 X 1.75 mm X 30 mm long bolts

• Slip ring assembly fasteners

Four size M8 X 1.25 mm X 20 mm long bolts

• Torque wrenches, capable of the following ranges:

24–74 N•m (18–55 lbf•ft),

203–815 N•m (150-600 lbf•ft);

108–325 N•m (80–240 lbf •ft)

93 N•m (69 lbf•ft)

• Cables (transducer and BNC, plus customer-supplied from transducer

interface to data recorder)

• Tie wraps

• Data recorder

• Power supply–12 V DC or optionally 24 V DC

power supply

1 If 24 Vdc compatible electronics was ordered at time of purchase.