Instruction Manual
Table Of Contents
- Contents
- Technical Support
- Preface
- Hardware Overview
- Software Utilities
- Setting up the Transducer Interface
- Installing the Transducer
- Contents
- Hazard Icon
- Road and Track Vehicles
- Road Simulator
- Analyzing SWIFT Data
- Maintenance
- Troubleshooting
- Assembly Drawings

SWIFT 10 ATV Sensors Setting up the Transducer Interface
51
Setting up the Transducer Interface
Overview Two different software configurations are used by the TI, depending on whether
you will be using the SWIFT sensor on the test track (typical for spinning
application) or in the laboratory (typical for non-spinning or fixed application).
Angular transformation is required on the test track only. If you are using the
same transducer and TI for data collection on the test track and simulation testing
in the laboratory, you must change the software configuration in the TI when you
change testing modes.
Contents USB driver installation 52
Select a Zero Method 54
Calibration File Elements 55
Upload the Calibration File 56
Edit the Calibration File 57
Download the Calibration File 60