Instruction Manual
Table Of Contents
- Contents
- Technical Support
- Preface
- Hardware Overview
- Software Utilities
- Setting up the Transducer Interface
- Installing the Transducer
- Contents
- Hazard Icon
- Road and Track Vehicles
- Road Simulator
- Analyzing SWIFT Data
- Maintenance
- Troubleshooting
- Assembly Drawings
SWIFT 10 ATV Sensors Maintenance
113
3. Hand wash the transducer after each testing session (especially if the
transducer was exposed to corrosive and abrasive materials, such as salt or
sand) with a gentle detergent, such as dish soap, and a soft sponge or brush
with non-metal bristles. Be very careful when cleaning around areas where
RTV is used to seal the transducer so as not to break the seal.
4. Inspect the label affixed to the side of the transducer. Replace the label if it
becomes loose, has been lost or is unreadable.