User Manual

Series 252 Servovalve Product Information Introduction

Introduction

The MTS Series 252 Servovalves are designed for use with actuators requiring

3.8 to 227 L/min (1 to 60 gpm) of fluid flow.

Contents About the Servovalve 14

Servovalve Function 14

Servovalve Applications 16

252 Servovalve General Specifications 20

252 Servovalve Flow Ratings 21

252 Servovalve Performance Characteristics 22

252 Servovalve Dimensions 23

Series 252.2x/4x Servovalve

Note The Series 252.2x/4x Servovalves are available in two versions. Both

versions are interchangeable and have similar specifications.

Important If you are replacing an existing servovalve and you encounter any

component interference or alignment issues, contact MTS

Technical support. Trying to reposition components without

knowing the ramifications can cause equipment damage.

What you need to

know

MTS Systems Corporation assumes that you know how to use your controller.

See the appropriate manual for information about performing any controller-

related step in this manual’s procedures. You are expected to know how to

perform the following procedures.

• Turn hydraulic pressure on and off.

• Select a control mode.

• Manually adjust the actuator position.

• You should have experience installing or servicing servohydraulic

equipment.

Series 252.3x Servovalve

Revision C Revision G