User Manual

Series 248 Actuator Product Information Installation
31
Installation
Installing the Series 248 Actuators depend on the testing application.
• For structural or vibration testing, the actuator is typically configured with a
pedestal base or a static support, and is bolted to a reaction mass.
• Fixtures, such as a vibration table or a wheel pan, can be attached to the
piston rod end using the internal thread circular hole pattern or with a
connector stud using the center position internal thread.
Contents How to Install a Fixture to the Actuator 32
How to Connect Cables to Actuator 33
How to Connect Hydraulics to the Actuator 34