Manual

Actuator Dimensions
DescriptionItem
BASIC CYLINDER1
FRONT END CAP2
REAR END CAP3
A (Cushion)4
Stroke Length5
C min.6
B+ Stroke Length7
-6 Drain8
Rod Insert: “M” thread size, “N” deep9
Structural10
Load Frame11
“D” holes, “E” thread size, “F” deep, equally spaced on a “G” diameter12
4 holes, “H” thread size, “F” deep, equally spaced on an “L” diameter13
8 holes, “H” thread size, “K” deep, spaced as shown on an “L” diameter14
Each dimension shown in this figure is listed in the table that follows.
Actuator Dimensions (SI Metric)
ModelItem
244.51244.41244.31244.23244.22244.21244.20244.12244.11Units
nonenone5.16.47.610.210.215.215.2mmA
342.6311.6256.5233.7233.7246.4246.4238.3238.3mmB
38.128.425.425.425.425.425.425.425.4mmC
4
88888882 or 42 or 4holes
5
D
1 - 81 - 85/8 - 111/2 - 131/2 - 131/2 - 131/2 - 133/8 - 163/8 - 16UNCE
4
This area includes a fully retracted standard length piston rod.
5
Load unit actuators have four mounting holes; structural actuators have two mounting holes.
24 Series 244 Actuators Product Information
Introduction