Instruction Manual

Periodic Time Event activity
about 438
example 438
properties 439
recurrence 439
Phase Lag property
Sweep activity 356
Plot Previous Test Runs panel 530
point pick 526, 537, 557, 576
point-by-point processing 150
Points per Frame property
Time History Input activity 391
Polynomial function 218
PolynomialFit function 219
Power panel 617
pretest variable 178
preventing actuator movement
adjusting span setpoint 427
Preview property
Custom Message Window activity 450
procedure
design 316
run 316
procedure message 46
Procedure Tab 98
Prole activity
about 347
program actions
Message Log activity 465
Program Interlock signal in DAQ processes 376
program state
Ramp activity 349
properties
absolute end level 1
Sweep activity 356
absolute end level 2
Sweep activity Relative End Level 2 property
Sweep activity 356
action
Digital Input activity 399
Limit Detection activity 403
Time History Output activity 362
Time History Sequence Output activity 370
add
Custom Message Window activity 450
add separator
Custom Message Window activity 451
advanced
Cycle activity 332
Ramp activity 351
button alignment
Custom Message Window activity 450
buttons
Custom Message Window activity 450
channel list
Cycle activity 333
properties (continued)
channel list (continued)
Ramp activity 351
Sweep activity 355
channel reference
Peak-Valley Change Detector activity 408
channel unit
Time History Output activity 362
Time History Sequence Output activity 370
compensator
Cycle activity 332
Ramp activity 351
Sweep activity 355
Time History Output activity 361
Time History Sequence Output activity 369
completion
Limit Detection activity 402
continuous sampling
High-Speed Data Acquisition activity 384
control mode
Cycle activity 333
Ramp activity 351
Sweep activity 356
Time History Output activity 362
Time History Sequence Output activity 369
create message window
Custom Message Window activity 449
create trend response le
Time History Input activity 391
Time History Output activity 363
Custom Waveform + DAQ activity 326–327
cycle
Peak-Valley Change Detector activity 409
cycles to display 494, 510
descriptor
Time History Output activity 363
Time History Sequence Output activity 369
difference allowed
Cycle Change Detection activity 397
Digital Input activity 398
digital input list
Digital Input activity 399
drive has an offset
Time History Output activity 361
Time History Sequence Output activity 368
duration
DAQ activity 145
Ramp activity 351
edit
Custom Message Window activity 450
enable after
Peak-Valley Change Detector activity 408
enable SSL
Send Email activity 78
end level
Ramp activity 352
653
Index