Instruction Manual

DescriptionNumber
DAQ List: Data Acquisition 1
Trigger 1: Timed
Buffer Size: 1 count
Save data to variables: Yes, automatically map variables (signal-dependent variables)
Configure the Set Span and Setpoint activity:5
Maintain command: Disabled
Monitor: Continuous
Channel: Axial
Control Mode: Displacement
Span; Setpoint: Defined as calculated variable values as shown below.
Allow activity to execute when test is stopped: Enabled
Configure the State Change Detection activity:6
Program state change: Stopping
Note:
If the test is stopped, the Set Span and Setpoint activities continue since the Allow
activity to execute when the test is stopped check box is enabled.
Select the State Change Detection as a Terminal Path (see activity number 3).
Below the Parallel Paths activity, add a serial Set Span and Setpoint activity configured for
maintaining command. Property settings:
7
Maintain command to prevent movement: Enabled
Channel: Axial
Control Mode: Displacement
Span: 100%
Setpoint: 0 (units)
Allow activity to execute when test is stopped: Enabled
Add a Ramp activity to ramp to zero. Property settings:8
Timing Type: Time
MTS TestSuite | 433
Test Activities