User Manual
Model 680.01 High-Temperature Grips
22
Install the Grips
An attachment kit is required for attaching each grip to the load unit. Kit
selection should be based on the mounting thread s provi ded on the grips, which
must match corresponding threads on the device (force transducer or actuator
rod), to which the grip is to be attached. Refer to the informatio n about the
attachment kits.
Grip Installation Components
Required equipment • An attachment kit for the actuator
• An attachment kit for the force transducer
• Molykote G•N paste lubricant (MTS part number 011-010-217 is a 2.8 oz.
tube; other sizes are available)
Crosshead or
Force T ransducer
Spiral
Washer
Set
Stud
Upper Grip
Lower Grip
Spiral
Washer
Set
Stud
Actuator Rod
Load Unit
Base Plate