User Manual

Model 680.01 High-Temperature Grips
21
Installation
This section describes how to install the Model 680.01 High Temperature Grips
into a load unit.
Contents Install the Grips 22
Install the Hand-Operated Hydraulic Pump 25
Install the Cooling Kit 26
Preload the Spiral Washers 27
Grip W ater Cooling Assembly Configurations for Servohydraulic Frames
29
Typical installation The following diagram show s the main steps to install th e grips. Usually the grips
are installed along with a furnace. In such cases, these instructions should be
used in conjunction with those provided for the furnace.
Typical Grip Installation
Install the Grips
Install the Hand-
Operated
Hydraulic Pump
Install the
Cooling Kit
Preload the Spiral
Washers