Service Manifold Manual
Table Of Contents
- Technical Support
- Preface
- Introduction
- About the Hydraulic Service Manifold (HSM)
- 293.32 HSM Component Identification
- HSM Fluid Flow
- HSM Filtering
- HSM Pressure Control
- About HSM Pilot Pressure
- HSM Accumulators
- HSM Slow Turn-On
- HSM Rapid Pressure Reduction
- Model 239.32 HSM Hydraulic Schematic
- Model 293.32 HSM Dimensions
- Model 293.32 HSM Specifications
- Safety
- General Safety Practices: Hydraulic Power Units and Hydraulic Service Manifolds
- Hazard Placard Placement
- Read all manuals
- Locate and read hazard placards/labels
- Specimen Temperature Changes
- Know facility safe procedures
- Know controls
- Have first aid available
- Know potential crush and pinch points
- Be aware of component movement with hydraulics off
- Know electrical hazards
- Keep bystanders safely away
- Wear proper clothing
- Remove flammable fluids
- Check bolt ratings and torques
- Practice good housekeeping
- Protect hoses and cables
- Provide proper hydraulic fluid filtration
- Protect accumulators from moving objects
- Do not exceed the Maximum Supply Pressure
- Do not disable safety devices
- Use appropriately sized fuses
- Provide adequate lighting
- Provide means to access out-of-reach components
- Wear appropriate personal protection
- Handle chemicals safely
- Know system interlocks
- Know system limits
- Do not disturb sensors
- Ensure secure cables
- Stay alert
- Contain small leaks
- Stay clear of moving equipment/avoid crush points
- Know the causes of unexpected actuator motions
- Do not use RF transmitters
- Know compressed gas hazards
- General Safety Practices: Hydraulic Power Units and Hydraulic Service Manifolds
- Installation
- Operation
- Maintenance
Warning:
Warning notices indicate the presence of a hazard with a medium level of risk which, if ignored,
can result in death, severe personal injury, or substantial property damage.
Caution:
Caution notices indicate the presence of a hazard with a low level of risk which, if ignored,
could cause moderate or minor personal injury or equipment damage, or could endanger test
integrity.
Other special text conventions
Important:
Important notices provide information about your system that is essential to its proper
function. While not safety-related, if the important information is ignored, test results may
not be reliable, or your system may not operate properly.
Note:
Notes provide additional information about operating your system or highlight easily
overlooked information.
Recommended:
Recommended notes provide a suggested way to accomplish a task based on what MTS
has found to be most effective.
Tip:
Tips provide helpful information or a hint about how to most efficiently accomplish a task.
Access:
Access provides the route you should follow to a referenced item in the software.
Examples show specific scenarios relating to your product and appear with a shaded
background.
Special terms
The first occurrence of special terms is shown in italics.
Illustrations
Illustrations appear in this manual to clarify text. They are examples only and do not necessarily represent
your actual system configuration, test application, or software.
12 | Model 293.32 Hydraulic Service Manifold
Preface