Service Manifold Manual
Table Of Contents
- Technical Support
- Preface
- Introduction
- About the Hydraulic Service Manifold (HSM)
- 293.32 HSM Component Identification
- HSM Fluid Flow
- HSM Filtering
- HSM Pressure Control
- About HSM Pilot Pressure
- HSM Accumulators
- HSM Slow Turn-On
- HSM Rapid Pressure Reduction
- Model 239.32 HSM Hydraulic Schematic
- Model 293.32 HSM Dimensions
- Model 293.32 HSM Specifications
- Safety
- General Safety Practices: Hydraulic Power Units and Hydraulic Service Manifolds
- Hazard Placard Placement
- Read all manuals
- Locate and read hazard placards/labels
- Specimen Temperature Changes
- Know facility safe procedures
- Know controls
- Have first aid available
- Know potential crush and pinch points
- Be aware of component movement with hydraulics off
- Know electrical hazards
- Keep bystanders safely away
- Wear proper clothing
- Remove flammable fluids
- Check bolt ratings and torques
- Practice good housekeeping
- Protect hoses and cables
- Provide proper hydraulic fluid filtration
- Protect accumulators from moving objects
- Do not exceed the Maximum Supply Pressure
- Do not disable safety devices
- Use appropriately sized fuses
- Provide adequate lighting
- Provide means to access out-of-reach components
- Wear appropriate personal protection
- Handle chemicals safely
- Know system interlocks
- Know system limits
- Do not disturb sensors
- Ensure secure cables
- Stay alert
- Contain small leaks
- Stay clear of moving equipment/avoid crush points
- Know the causes of unexpected actuator motions
- Do not use RF transmitters
- Know compressed gas hazards
- General Safety Practices: Hydraulic Power Units and Hydraulic Service Manifolds
- Installation
- Operation
- Maintenance
• Record the name of the person who helped you.
• Write down any specific instructions.
After you call
MTS logs and tracks all calls to ensure that you receive assistance for your problem or request. If you
have questions about the status of your problem or have additional information to report, please contact
Technical Support again and provide your original case number.
Problem Submittal Form in MTS Manuals
Use the Problem Submittal Form to communicate problems with your software, hardware, manuals, or
service that are not resolved to your satisfaction through the technical support process. The form includes
check boxes that allow you to indicate the urgency of your problem and your expectation of an acceptable
response time. We guarantee a timely response—your feedback is important to us.
You can access the Problem Submittal Form at www.mts.com > Contact Us (upper-right corner) > In the
Subject field, choose To escalate a problem; Problem Submittal Form
10 | Model 293.32 Hydraulic Service Manifold
Technical Support