Owner's manual

Enclosure with Light Curtain
DescriptionItem
Test Area Guard1
Control Panel2
Light Curtain Elements3
To operate the enclosure with a light curtain:
1. Place the part to be tested on the lower platen.
2. Push both Start buttons simultaneously.
The test proceeds until complete and the actuator rod returns to the end-of-test position.
3. Perform an applicable pass or fail procedure. This is defined by the customer based on testing and part
handling requirements.
4. Remove the tested part.
5. Repeat Steps 1 through 5.
MTS Landmark™ Tabletop Load Units Product Information 71
Operation