Instruction Manual

Adjusting the Hydraulic Locks
DescriptionItem
Tighten1
Bottom Out Position2
Loosen, then hand tighten.3
7. Loosen each of the hydraulic lock cap screws 1/4 turn.
Loosening the Hydraulic Lock Cap Screws
DescriptionItem
Loosen 1/4 turn.1
8. Turn on electrical power at the test controller if you have not already done so.
9. Reset any active interlocks at the test controller.
10. Turn on high hydraulic pressure.
11. Return the Lock Control to the lock crosshead position to pressurize the hydraulic locks.
MTS Landmark™ Floor Standing Load Units Product Information 89
Maintenance