Owner manual

DescriptionControl/IndicatorNumber
2. On the IOP, press the white Start Pump button.
3. On the computer, reset the interlock in the TW application.
4. On the handset, press the Enable button.
5. Turn the grip control knob to open.
Press the switch to On (I) to turn on power and Off (O) to turn
off power.
Power Supply Switch2
When illuminated, hydraulic power is on.Power Indicator3
Starts the hydraulic pump motor.Start Pump Button4
Stops the hydraulic pump motor.Stop Pump Button5
When illuminated, a hardware failure in the system has been
detected. Stop using the machine and contact MTS service for
support.
Fault Indicator6
When illuminated, check and change the oil filter or
high-pressure filter, or change the oil, if necessary.
Dirty Oil Indicator7
Handset
The MTS Criterion Series 60 systems have an interactive handset with control buttons, LED indicators,
and a text display. The handset rests in a holder attached to the test area guard or frame and features a
compact ergonomic design for both right-handed and left-handed operators. There is a large text display
that provides test status information. The handset is used to move the upper crosshead and table, and to
control test starting and stopping, load, and displacement while the operator stands close to the test
specimen.
MTS Criterion
™
Series 60 | 43
System Introduction