Owner manual

MTS Criterion Series 60 Systems Computer Front Panel Ports and Indicators
DescriptionPort / IndicatorNumber
You can import or export .proj test files into or out of the computer
using the USB interface.
Dual USB Ports1
Use this port to connect the PS/2 keyboard to the computer.PS/2 Port2
Locks the front panel door. A key is required to open the door.Key Lock3
The LED indicators show computer system status. They do not indicate
the load frame status.
LED Indicators4
Key-Access Door Switches and Buttons
The System Reset button and Power switch are located behind the key-access door.
MTS Criterion Series 60 Systems Computer Front Panel Buttons and Switches
DescriptionButton/Switch
Use this switch to start the system (system reboot).System Reset Button
Use this switch to turn on or turn off power to the computer.Power On/Off Switch
Load Frame Overview
The load frame is composed of a base, actuator, test table, lower crosshead, and upper crosshead. The
test table is connected to the upper crosshead by the columns to form a stiff frame, and the test table is
connected to the piston through a load cell. There are two testing spaces in the frame: the tension space
is between the upper and lower crossheads, and the compression space is between the lower crosshead
and the test table. Both the tension and compression spaces can be adjusted by moving the lower crosshead
up and down according to your testing needs.
In the software, the term actuator is synonymous with the upper crosshead and table. For example, the
TWX application Actuator Control panel provides the controls for moving the upper crosshead and table.
36 | MTS Criterion
™
Series 60
System Introduction