Instruction Manual

MTS Criterion™ Series 60 Product Manual

Controller Connections

Installation

J14 Emergency Stop This connector is intended to connect to a remote Emergency Stop switch. If not

used, a jumper plug must be installed. If you are building a cable, the maximum

length is 30.48 m (100 ft) with 18 AWG. The switch should be wired normally

closed, such that when the switch is pressed, an interlock is generated.

Pin assignment is as follows:

ESTOP3 = emergency stop switch with two sets of contacts (optional remotely

mounted).

ESTOP_OUT = optional ESTOP output for accessory, includes two contact

outputs and one feedback.

7 No Contact

8 VCC

9 DIN 1-

10 DIN 2-

11 DIN 3-

12 OUT 1-

13 OUT 2-

14 OUT 3-

15 AGND

Pin Assignment (Continued)

IN SIGNAL

Pin Assignment

PIN SIGNAL

1 ESTOPB_OUT-

2 No Contact

3 ESTOP_OUT_MONITOR-

4 ESTOP_OUT_MONITOR+

5 ESTOP3B+

6 ESTOPA_OUT-

7 ESTOP3B-

8 ESTOP3A+

9 ESTOPB_OUT+

10 No Contact

11 No Contact

12 No Contact

13 ESTOP3A-