Instruction Manual

Controller Connections

MTS Criterion™ Series 60 Product Manual Installation

J11 Guard This connector is intended to connect to a test area enclosure switch that opens

when the door is opened. C60 series do not use this function, a jumper plug must

be installed. A jumper plug must be installed. If you are building a cable, the

maximum length is 30.48 m (100 ft) with 22 AWG. The switch should be wired

normally closed, such that when the switch opens, an interlock is generated. Pin

assignment is as follows:

GUARD = test area guard switch with two contacts.

GUARD_CONFIG = configuration jumpers in the cable.For speed limit when

test are guard door open jumper Guard_config1+ to Guard_config1- and

Guard_config2+ to Guard_config2-. For interlock when guard door open leave

Guard_config unconnected.

J12 Digital I/O The connector is the MTS Insight digital I/O control connector. It is connected

with J5

Digital I/O connector through a jumper.

J13 Digital I/O User Digital I/O signals include three optically isolated inputs, three optically isolated

outputs, and 12 V power. Functions of each digital input or output are software

selectable. A typical example might be connecting an external switch; see

“Additional Digital I/O Information” on page 93. Pin assignment is as follows:

Pin Assignment

PIN SIGNAL

1 GUARD 1A+

2 GUARD2A+

3 GUARD_CONFIG1+

4 No Contact

5 GUARD_CONFIG2-

6 GUARD1A -

7 GUARD2A-

8 GUARD_CONFIG1

9 GUARD_CONFIG2+

Pin Assignment

PIN SIGNAL

1 DIN 1+

2 DIN 2+

3 DIN 3+

4 OUT 1+

5 OUT 2+

6 OUT 3+