Instruction Manual

Controller Connections

MTS Criterion™ Series 60 Product Manual Installation

J5 Digital I/O Digital I/O signals include three optically isolated inputs, three optically isolated

outputs, and 12 V power. Functions of each digital input or output are software

selectable. J5 should be connected to J12 to make the controller board and

interface board communicate with each other. Pin assignment is as follows:

J6 and J7 Monitor Two monitor connectors are provided. There are several possible uses for analog

monitor outputs: external data acquisition, tuning, troubleshooting, and so forth.

For tuning, it is desirable to monitor command and feedback, or command and

error, simultaneously while changing the controller parameters. Therefore, two

monitor outputs are provided. Specifics for these connectors are:

• Analog +/-10.5 V

• Calibrated to +/-10 V

• 16-bit resolution minimum

• BNC connectors

Pin Assignment

PIN SIGNAL

1 In 1+

2 In 2+

3 In 3+

4 Out 1+

5 Out 2+

6 Out 3+

7 No Contact

8 +12V

9 In 1-

10 In 2-

11 In 3-

12 Out 1-

13 Out 2-

Out 3-

15 Analog GND