Instruction Manual

MTS Criterion™ Series 60 Product Manual

Controller Connections

Installation

J4 Encoder This connector is intended for an encoder-based extensometer. Specifics for this

connector are:

• Power: +5 V +/- 0.25 V at 100 mA max

• Signals: Quadrature A and B with index I

• Logic: Differential receivers (can connect single ended)

• Maximum Rate: 100,000 lines/sec = 400,000 counts/sec

Pin assignment is as follows:

Pin Assignment

PIN SIGNAL

1 TEDS data

2 A+

3 A-

4 +5 V

5 I+

6 I-

7 Analog GND

8 B+

9 B-

10 TEDS ground