Instruction Manual

Specifications

MTS Criterion™ Series 60 Product Manual Introduction

Encoder This is intended to connect the frame displacement sensor to the encoder on the

Insight Controller. It is DC-powered and collects the digital encoder signals

frome the displacement sensor. Pin Assignment is as follows:

Limits This connector is intended to connect the frame limit and the logic board. It is

used to transmit the state signal of the frame limit. Pin assignment is as follows:

14 TEDS-

15 EXS-

Pin Assignment (Continued)

IN SIGNAL

Pin Assignment

PIN SIGNAL

1 A+

2 A-

3 No Contact

4 GND

5 VCC

6 No contact

7 Shield

8 TEDS+

9 No Contact

10 B-

11 No Contact

12 I+

13 I-

14 TEDS-

15 B+

Pin Assignment

PIN SIGNAL

1 PISTON COM

2 PISTON NO

3 XHD UP NC

4 XHD LO COM

5 XHD LO NO