Owner's manual

MTS Criterion

Series 40 Product Manual

Installing Cables

Installation

J14 E- Stop This connector is intended to connect to a remote Emergency-Stop switch. If not

used, a jumper plug must be installed. If you are building a cable, the maximum

length is 30.48 m (100 ft) with 18 AWG. The switch should be wired normally

closed, such that when the switch is pressed, an interlock is generated. Pin

assignments are as follows:

• ESTOP3 = emergency stop switch with two sets of contacts (optional

remotely mounted).

• ESTOP_OUT = optional ESTOP output for accessory, includes two contact

outputs and one feedback. For use with pneumatic/hydraulic grip controls,

furnaces, environmental chambers, and so on.

IN SIGNAL

1 ESTOPB_OUT-

2 No Contact

3 ESTOP_OUT_MONITOR-

4 ESTOP_OUT_MONITOR+

5 ESTOP3B+

6 ESTOPA_OUT-

7 ESTOP3B-

8 ESTOP3A+

9 ESTOPB_OUT+

10 No Contact

11 No Contact

12 No Contact

13 ESTOP3A-

14 ESTOPA_OUT+

15 No Contact

Criterion_product manual.book Page 78 Monday, July 28, 2014 3:52 PM