Owner's manual

Installing Cables

MTS Criterion

Series 40 Product Manual

Installation

J13 Digital I/O User Digital I/O signals include three optically isolated inputs, three optically isolated

outputs, and 12 V power. Functions of each digital input or output are software

selectable. A typical example might be connecting an external switch; see

“Additional Digital I/O Information” on page 125. Only DIN1 and DOUT2 & 3

are available for external use. DIN2 & DOUT1 are used for Fault Status

communications with the software. DIN3 is used for Enclosure door switch

status. Pin assignments are as follows:

Note If the optional enclosure is not used, DIN3 is still required by the control

system to bypass the low-speed safety system.

PIN SIGNAL

1 DIN1+

2 DIN2+

3 DIN3+

4 DOUT1+

5 DOUT2+

6 DOUT3+

7 No Contact

VCC

9 DIN1-

10 DIN2-

11 DIN3-

12 DOUT1-

13 DOUT2-

14 DOUT3-

15 Analog GND

Criterion_product manual.book Page 77 Monday, July 28, 2014 3:52 PM