Owner's manual

Dual-Column Load Frames
MTS Criterion
®
Series 40 Product Manual
Installation
67
Rear of dual-column
load frames
A typical installation procedure for installing the rear enclosure for dual-column
units is provided following the figure.
1. Remove the M6 X 20mm socket head screws (Item 3) from the frame.
2. Position the left-side panel assembly (Item 1) on the frame base, and thread
the screws through the holes on the frame.
3. Secure the left-side panel to the frame using four M6X40 mm buttonhead
cap screws (Item 6). Do not over-tighten. You can position for alignment
after the right-side panel (Item 5) and horizontal bar (Item 4) are installed.
I
TEM DESCRIPTION
1 Left Side Panel Assembly
2 M6 Butt Fastener
3 M6 X20 mm Socket Head Screw
4 Horizontal Bar
5 Right Side Panel Assembly
6 M6 X40 mm Socket Head screw
7
Back Door
1
2
3
4
5
6
7
Rear of Dual-Column Load Frame
Criterion_product manual.book Page 67 Monday, July 28, 2014 3:52 PM