Owner's manual

Advantage™ Pneumatic Grips

Installation Without Using the Mounting Pin

Installation

Installation Without Using the Mounting Pin

This section describes how to install the Advantage Pneumatic Grips by bolting

them directly to a load unit actuator and force transducer (usually in a

servohydraulic test system).

Note You will need the appropriate attachment kit to install the grips in a

servohydraulic load unit.

Non-pinned Installation Components

End Cap

Cap Screw

Grip Assembly

Air Fitting

Actuator

Spacer

10 N 200 N/2000 N 10,000 N

Spring Pin

Threaded

Adapter

Jam Nuts

Washer