Instruction manual

CIS ANI Digits Manipulation and Gateways Enhancements Page 1053 of 3156
Features and Services
11 LD 16 - Configure the ANI table entry and CAC conversion table for
Incoming CIS DTI2 route.
12 LD 16 - Configure the ANI table entry for all other route types (ISDN,
incoming CIS analog, incoming DTI2 and DPNSS).
13 LD 88 - Configure the CAC for CIS signaling.
LD 15 - Configure ANI Table for telephones
Prompt Response Description
REQ: NEW
CHG
Add new data.
Change existing data
TYPE: ANI Automatic Number Identification
... ... ...
ANLD xx...xx ANI listed directory number (for North American
trunk)
CIS_ANI YES (NO) CIS ANI option.
If CIS_ANI=YES, the next subprompts will be
prompted, allowing the configuration of ANI
entries for CIS ANI message composing.
If CIS_ANI=NO, the following sequence of
subprompts is skipped.
- S_SIZE (0)-2000 Maximum number of ANI entries for sets that can
be configured.
If S_SIZE=0, next prompts are skipped.
If <CR> is entered when REQ=NEW, it defaults to
0 and next prompts are skipped.
The S_SIZE can’t be decreased if the entries
between the old size and the new one are not
empty.