Instruction manual

Page 1052 of 3156 CIS ANI Digits Manipulation and Gateways Enhancements
553-3001-306 Standard 10.00 January 2002
CIS Analog Three Wire Trunks feature requires:
• International Supplementary Features (SUPP) package 131
• Flexible Numbering Plan (FNP) package 160
• Flexible Tones and Cadences (FTC) package 125
• Trunk Fail Monitor (TFM) package 182
• Meridian 1 IPE package (XPE) package 203 (required for outgoing X3W
packs)
• Fast Tone and Digit Switch (FAST_TDS) package 87 (required for
outgoing E3W package)
CIS ANI Digits Manipulation feature implementation
This section contains the overlay procedures required to configure the CIS
ANI Digits Manipulation feature. The CIS Gateways Enhancements feature
implementation section begins on page 1062.
Task summary list
The following is a summary of the tasks in this section:
1 LD 15 - Configure ANI Table for telephones
2 LD 16 - Create or modify outgoing CIS route data block.
3 LD 10 - Define ANI entry for analog (500/2500) sets.
4 LD 10 - Configure the CAC for CIS and MFC signaling for analog 500/
2500 sets.
5 LD 11 - Configure ANI entry for Meridian 1 proprietary sets.
6 LD 11 - Configure the CAC for CIS and MFC signaling for digital sets.
7 LD 27 - Configure ANI entry for Basic Rate Interface (BRI) lines.
8 LD 27 - Configure the CAC for CIS and MFC signaling for BRI sets.
9 LD 15 - Configure the ANI route table and CAC conversion table.
10 LD 16 - Configure the ANI table entry in the Route Data Block for
incoming R2MFC route.