Instruction manual

Page 1050 of 3156 CIS ANI Digits Manipulation and Gateways Enhancements
553-3001-306 Standard 10.00 January 2002
There is no cross checking of the CAC Conversion table entries associated
with a CIS or R2MFC route against the CAC Conversion table in the
customer Data Block. If a CAC Conversion table entry is removed from the
CAC Conversion table and this entry is stilled
assigned to a route, CAC in this
case is built using the default CAC Conversion table entry, CIS_ENT number
0 for an incoming CIS route and MFC_ENT number 0 for an incoming MFC
route. Additionally ERR9051 message is issued at call processing time.
It is possible to associate an undefined CIS_ENT or MFC_ENT to a route.
Then, when constructing CAC if CIS_ENT or MFC_ENT is still undefined,
default CIS_ENT or MFC_ENT (number 0) is used and ERR9051 message
is issued at call processing time.
Feature interactions
This section identifies feature interactions for CIS ANI Digits Manipulation
and Gateways Enhancements.
CIS ANI Digits Manipulation feature interactions
CIS Three Wire Analog Trunk
CIS ANI digits manipulation feature modifies Automatic Number
Identification.
CIS Digital Trunk Interface
CIS ANI digits manipulation feature modifies Automatic Number
Identification.
CIS MF Shuttle
CIS ANI digits manipulation feature modifies Automatic Number
Identification.
CIS Gateways Enhancements
Some changes introduced in CIS ANI digits manipulation feature will impact
on CIS Gateways Enhancements feature. These changes are listed below:
• The size of the ANI is configurable on a per outgoing CIS route basis.
• Valid responses for LEC, ADDG and ANDN programmed on the
outgoing CIS route are modified.