Instruction manual

Italian Periodic Pulse Metering Page 1869 of 3156
Features and Services
Feature packaging
This feature is packaged under the existing 2 Mbps Digital Trunk Interface
(DTI2) package 129. Periodic Pulse Metering/Message Registration (MR)
package 101 is required for its operation.
Feature implementation
Task summary list
The following task is required:
LD 73 – Configure the Italian PPM option.
LD 73 – Configure the Italian PPM option.
Feature operation
No specific operating procedures are required to use this feature.
Prompt Response Description
REQ CHG Change.
TYPE DTI2 2 Mbit digital trunk.
FEAT LPTI Loop timers.
LOOP nnn Loop number.
...
ITPP (NA) YES NO Italian PPM option. If this is set, PPM pulses are only
counted when the B bit is zero.
NA = The DTI2 card is not capable of Italian PPM (the
default).
YES = Turn on Italian PPM in DTI2 card.
NO = Turn off Italian PPM in DTI2 card.