Instruction manual

International Meridian 1 Page 1843 of 3156
Features and Services
LD 97 – Configure system parameters for peripheral equipment in configuration record 2.
TN I s c u
c u
Terminal Number
Option 11C
POLR a...a Polarity of LED messages for DTD (a...a = (NORM) or REV)
XTDT (0)-7 Extended Tone Detector Table number.
-DTO (NO) YES Dial Tone Detection Only.
CDEN a...a Card Density (aa = SD, DD, or 4D)
TOTN I s c u
c u
To Terminal Number
Option 11C
Prompt Response Description
REQ CHG Change.
TYPE SYSP System parameters.
...
INTN (NO)
YES
µ-Law.
A-law.
CODE (0)-3 Used by Network Card firmware.
0 is the only valid entry (1-3 are reserved for future use).
CONT 1-(4)-15 Respond to the CONT prompt with the continuity error
threshold value between 1 and 15 (the default is 4).
CRCF 1-(4)-15 Respond to the CRCF prompt with the CRC failure
threshold value between 1 and 15 (the default is 4).
FLSH xxx yyyy Switch hook flash timing when International Supplementary
Features (SUPP) package 131 is equipped. Minimum and
maximum switch hook flash timer in milliseconds for analog
(500/2500 type) telephones, where:
xxx = 21-(45)-768, and
yyyy = xxx value-(896)-1275.