Instruction manual

Page 1800 of 3156 Intelligent Peripheral Equipment Software Support Enhancements
553-3001-306 Standard 10.00 January 2002
• XFCOT – The Autoguard function is enhanced with an Autoguard
Repeat Prevention (ATP) timer. This timer denies outgoing calls on a
trunk after seize failure during the time configured for ATP. Fastguard
functionality is added to prevent call collision between incoming and
outgoing calls. If a Fastguard message is received from a Central Office
Trunk (COT), the trunk unit is made busy immediately, thus avoiding
any outgoing call to seize this unit which would drive it back to a glare
state.
• XDID – This allows the Balance Impedance Adjustment to be
configurable and downloadable.
• XTD – Auto configuration of the XTD card with the XTD Table 0
parameters can now be enabled. If different parameters are required for
a specific XTD card, a new XTD table must be configured in LD 97. This
specific card has to be manually reconfigured with the newly defined
XTD table.
Operating parameters
The BPO signaling type is downloaded to the XFEM card using two hardware
IDs: EAM_BPO and EM4_BPO. These IDs are supported on the Dutch
XFEM card NT5K83DA, and the Italian XFEM card NT5K83GA.
The flexible XFALC Timer Download is supported on the country-specific
XFALC cards NT5K20XX, where XX is the country-specific suffix.
Fast guard is supported on the New Zealand NT5K18BA, and Australia
NT5K82BA/CA XFCOT cards.
The ARP timer for enhanced Autoguard applies only to Intelligent Peripheral
Equipment (IPE) analog loop-start CO trunks.
XTD auto configuration is supported on the global XTD card NT5K48AA.
The Fastguard functionality only applies for incoming Loop Start CO trunks.