Instruction manual

Page 1794 of 3156 Intelligent Peripheral Equipment Completion
553-3001-306 Standard 10.00 January 2002
L1 Signaling on XFEM
Task summary list
The following is a summary of the tasks in this section:
1 LD 16 – Configure L1 signaling on a XFEM TIE trunk route with
Proceed to Send expected after an outgoing seize and answer
supervision.
2 LD 14 – Configure a L1 Signaling trunk.
LD 16 – Configure L1 signaling on a XFEM TIE trunk route with Proceed to Send expected after
an outgoing seize and answer supervision.
Prompt Response Description
REQ NEW CHG Add new data or change existing data.
TYPE RDB Route data block.
...
TKTP TIE Trunk type.
CNTL YES Change control or timers.
- TIMR
DDL 0-(70)-1023 Dial Delay timer.
DSI 128-(34944)-
499200
Disconnect Supervision timer.
EOD 128-(13952)-
32640
End-of-dial timer.
ICF 0 Incoming Flash timer.
OFC 0 Outgoing Flash timer.