Instruction manual

Page 1792 of 3156 Intelligent Peripheral Equipment Completion
553-3001-306 Standard 10.00 January 2002
LD 16 – Configure a RON/TRON signaling trunk route.
Prompt Response Description
REQ NEW, CHG New, or change.
TYPE RDB Route data block.
...
TKTP TIE TIE trunk.
CNTL YES Change control or timers.
- TIMR Timer.
DDL 0-(70)-1023 Dial Delay timer. The DDL timer is set at 512 ms. for the RT
(RON/TRON) start arrangement.
DSI 128-(34944)-
499200
Disconnect Supervision timer.
EOD 128-(13952)-
32640
End-of-dial timer.
ICF 0-(512)-32640 Incoming Flash timer.
OGF 0-(512)-
32640
Outgoing Flash timer. The OGF timer is to be set to 384 ms.
for validation of the seize acknowledge message.
SST xx Seizure Supervision timer for trunks with delay dial (DDL),
wink (WNK), and ground (GRD) start arrangements.
xx = a minimum value of 1-(3)-15 seconds for GRD, and five
seconds for DDL, WNK, RT (RON/TRON) start
arrangement, and L1 signaling.
DTD YES Dial tone detection.
MDTD 1-(5)-31 Minimum dial tone detection delay for the route in seconds.
DLTN (NO) YES Provide dial tone to the far end.