Instruction manual

Integrated Messaging System Link Page 1775 of 3156
Features and Services
LD 15 – Add or change the IMS feature for a customer.
- CTYP aaaa Card type, where:
aaaa = DCHI, MSDL, MSPS, SDI, SDI2, SDI4, or XSDI.
- DNUM 0-15 Device number to be printed automatically (same as ADAN
number).
- USER APL This link is an Auxiliary Processor Link (APL).
TYPE PARM System parameters.
- AXQI (20)-255 Number of call registers to be used for receipt of messages
from the messaging system.
- AXQO (20)-255 Number of call registers to be used for output of messages
to the messaging system.
Note: If the number of call registers defined for the Meridian 1
system (prompt NCR) is within the range 80-1020, AXQI and
AXQO cannot exceed 25 percent of the system call registers.
Prompt Response Description
REQ: CHG Change.
TYPE: FTR CDR Gate Opener
CUST 0-99 Customer number.
OPT (MCX) MCI Message Center (excluded) included.
...
TYPE IMS Integrated message service options.
- IMS (NO) YES (Do not) allow changes to the IMS feature.
- IMA (NO) YES IMS feature (is not) or is enabled.
- - APL 0-15 Port number of the link to the messaging system.
- UST (NO) YES User Status Update (UST) feature (is not) or is enabled.