Instruction manual

Page 1768 of 3156 Instant ISM
553-3001-306 Standard 10.00 January 2002
21 Keycode validation successful.
Are you sure you wish to perform the upgrade? (y/n/[a]bort) :
22 In response to the prompt “Are you sure you wish to perform the
upgrade?,” enter
y.
If the new keycodes correct for instant activation, it will be activated without
further user action, and the following message is given:
Upgrade was completed and activated successfully.
Sysload is NOT needed!
If the keycode is not eligible for instant activation, a Sysload is needed to
activate the new keycode and the following message is given:
Upgrade was completed successfully.
Initiate a Sysload to activate the upgrade.
Reverting to the previous keycode with the KRVR command
On options 51C, 61C, and 81C systems, the KRVR command can be used to
revert to the old keycode “instantly.”
Note: The terms “old” and “new” keycode as discussed here refer to the
most recent previous KNEW command. The “old” keycode is the former
keycode, prior to the KNEW command. The “new” keycode is the
keycode that was activated by the KNEW command.
The old keycode is eligible for instant activation with the KRVR command if
the only difference between the old keycode and the new keycode is that some
or all of the ISM parameters in the old keycode are higher.
To revert to the old keycode:
• In overlay 143, enter the
KRVR command.
If the keycode is eligible for instant activation, it will be activated without
further user action, and the following system message is given:
CCBR020 New Keycode accepted and activated successfully. Sysload is
NOT needed!