Instruction manual

Page 1766 of 3156 Instant ISM
553-3001-306 Standard 10.00 January 2002
5 Indicate that the current Feature Sets and/or Packages will remain the
same by selecting “n” to the following requests.
• Do you wish to change feature sets? (y/n/[a]bort) : N
Keeping Current Feature Set.
• Do you wish to add packages? (y/n/[a]bort) : N
The current ISM Parameters are printed to the TTY.
6 The ISM parameters shown below are a sample configuration only.
Current ISM Parameters :
TNS (10)
AGNT (10)
ACDN (10)
AST (10)
DSL (10)
...
7 Do you wish to change any ISM parameters? (y/n/[a]bort) :
8 In response to the prompt “Do you wish to change any ISM parameters?
(y/n/[a]bort) :” enter
y.
9 The ISM parameters are prompted in sequence. Change the ISM
parameters appropriately, according to the new keycode:
The ISM parameters shown below are a sample configuration only.
Enter new ISM parameters, <cr> to leave unchanged:
TNS (10) -
AGNT (10) - 11
ACDN (10) -
AST (10) -
DSL (10) -
...
10 After all ISM parameters have been prompted, the new ISM parameters
are displayed and the prompt “Is this correct?” appears. Enter
y to
continue.