Instruction manual

Instant ISM Page 1759 of 3156
Features and Services
Instant ISM parameter upgrade using a keycode diskette
Perform the following to instantly activate a keycode without a Sysload:
Note: For a dual-CPU (redundant) system, leave the system in full
redundant mode (hard-disk and CPU redundancy).
1 Log in on a system terminal and load overlay 143.
>LD 143
CCBR000
.
2 Insert the new keycode diskette into the floppy drive on the active
IODU/C.
3 Enter the KDIF command and select keycode comparison options.
Note: Ensure that the new keycode does not lower ISM limits or reduce
features compared with the existing keycode. If you have determined that
the keycode lowers ISM limits or reduces features, do not continue with
the KNEW command, but contact your Nortel Networks order
management representative.
. KDIF
Please use: KDIF <param1> <param2>
with the following parameters:
Enter the keycode comparison option. The new keycode option is shown
in
bold.
NEW accepted new keycode
REC currently used keycode
OLD previously used keycode
F0 candidate keycode on diskette in /f0 floppy drive
F1 candidate keycode on diskette in /f1 floppy drive
HD candidate keycode which was uploaded to hard disk