Instruction manual

Page 1740 of 3156 Incremental Software Management
553-3001-306 Standard 10.00 January 2002
Printing ISM System Limits
When REQ is set to SLT in Overlay 22, ISM system limits are printed. The
limits established for the system, the used parameters, the remaining
parameters, and other system information is printed when REQ = SLT.
You can update the value of ISM limits either through sysload or the Instant
ISM feature. You can print the new ISM limits through Overlay 22 after the
update is complete.
In Overlays 10, 11, 22, and for the KSHO command in LD 143, if the limit of
an ISM is set to the maximum value of 32767 (Options 51C, 61C, and 81C),
it will not print. However, the TNs ISM is an exception, and the information
prints regardless of the value set.
For the KDIF command in LD 143, if the limit of an ISM is set to the
maximum value of 32767 (for Options 51C, 61C, and 81C) in both the
compared keycodes, the ISM information will not print. As previously noted,
the TNs ISM is an exception, and the information prints regardless of the
value set.
The following shows the Overlay 22 implementation table for printing
system limits.
LD 22 – Print system limits
Table 67 is an example of an Overlay 22 printout when REQ is set to SLT.
Table 67
Example of an Overlay 22 print out when REQ = SLT
Prompt Response Description
REQ SLT Print System Limits: Incremental Software Management.
REQ slt
TNs 400 LEFT 3 USED 397
AGNT 15 LEFT 3 USED 12
ACDN 15 LEFT 4 USED 11
AST 13 LEFT 3 USED 10