Instruction manual

In-Band Automatic Number Identification Page 1707 of 3156
Features and Services
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1 LD 16 – Identify the route as an In-Band Automatic Number
Identification route.
2 LD 23 – Send the IANI messages across the Auxiliary Processor Link
(APL).
LD 16 – Identify the route as an In-Band Automatic Number Identification route.
LD 23 – Send the IANI messages across the Auxiliary Processor Link (APL).
Feature operation
No specific operating procedures are required to use this feature.
Prompt Response Description
REQ NEW CHG Add or change an IANI route.
TYPE DID TIE Direct Inward Dialing (DID) or TIE route.
ISDN NO YES Enable or disable ISDN (cannot be configured on same
route as IANI).
AUTO (NO) YES (Do not) specify as an auto-terminating route.
IANI (NO) YES (Disable) enable the IANI route.
Prompt Response Description
REQ NEW CHG Add or modify an IANI route.
TYPE ACD IANI calls terminate at an auto-terminating ACD DN.
ISAP YES (NO) Enable IANI messaging across the AP link.