Instruction manual

Hot Line Page 1661 of 3156
Features and Services
LD 18 – Add or change a Hot Line Speed Call list.
Prompt Response Description
REQ NEW CHG OUT Add, change, or remove a Speed Call list.
TYPE HTL Hot Line List.
CUST 0-99
0-31
Customer number, as defined in LD 15.
For Option 11C.
LNSO 0-8190 Hot Line List number (only one Hot Line List per customer).
NCOS 0-99 NCOS to be assigned to calls accessing the list.
DNSZ xx Maximum number of digits in a list entry (4, 8, 12, 16, 20,
24, 28, or 31).
SIZE 1-1000 Maximum number of entries in the Speed Call list.
STOR xxx yy...y xxx = list entry number (0-9, 0-99, or 0-999).
yy...y = digits to be stored against the entry (must be equal
to or less than DNSZ).
- WRT (YES) NO Data (is) is not correct and list (can) cannot be updated.
The WRT prompt follows SIZE and STOR prompts asking
for confirmation of the data just entered. If data is correct,
enter YES or <CR>. A response of NO to WRT after SIZE
returns the REQ prompt. A response of NO to WRT after
STOR causes the data just entered to be ignored and a
restart message (SCH3213) to be generated.
A response of **** aborts the program. The last STOR value
is lost but all other values for which WRT was YES are
saved.
The following information is output with the WRT prompt:
ADDS: MEM: xxxxx DISK: yy.y (xxxxx is the amount of
protected memory; yy.y is the number of disk records
required for the new speed call list. Check the MEM AVAIL
and DISK REC AVAIL values output before the REQ
prompt).