Instruction manual

Page 1646 of 3156 Hong Kong Digital Trunk Interface
553-3001-306 Standard 10.00 January 2002
This feature also meets the requirement of requiring the Meridian 1, after a
trunk seizure, to wait 600 milliseconds before accepting the dialed digits from
the far end. This 600 milliseconds dialing delay is provided by the Dial Delay
Timer, whose maximum configurable delay has been extended to 1,023
milliseconds. The timer is set on a per-route basis.
Operating parameters
Hong Kong Digital Trunk Interface modification applies only to 1.5 Mbits
DTI trunks.
Feature interactions
There are no feature interactions associated with this feature.
Feature packaging
This feature is packaged under 1.5 Mbps Digital Trunk Interface (DTI)
package 75.
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1 LD 14 – Respond to the CLS prompt by entering HKA to allow the Hong
Kong feature modification.
2 LD 16 – Enter a dialing pause for the Dial Delay Timer at the Time
prompt:
LD 14 – Respond to the CLS prompt by entering HKA to allow the Hong Kong feature
modification.
Prompt Response Description
...
CLS (HKD) HKA Hong Kong DTI (denied) allowed.
May only be used with DTI TNs with DTN CLS on DID or
TIE routes.