Instruction manual

Held Call Clearing Page 1641 of 3156
Features and Services
Conference
Active Conference calls are cleared by an on-hook or Release key action.
Conference calls being held are cleared by an on-hook action only, and not by
a Release key action. In either case, all other parties on the conference remain
connected.
Handsfree
For a set equipped with a Handsfree add-on unit, the on-hook action is
suppressed if the Handsfree key is pressed simultaneous to the on-hook. In
this case, all active and held calls on the set are not affected by the on-hook
action. For a Meridian M1000 or digital telephone, an on-hook action does
not affect an active call on the set. In all cases, a Release key action clears an
active call, whether in handsfree mode or not.
Misoperation on Call Transfer
An on-hook action clears a call that is put on hold during Call Transfer. This
action may lead to a misoperation if the user of the set from which the call is
being transferred goes on-hook before a valid DN is dialed. In this case, the
misoperation is handled in the same manner as for a 500-type set.
On Hold on Loudspeaker
Going on-hook when Held Call Clearing is activated will clear the
loudspeaker as for a normal held call. Therefore, it is recommended not to use
this feature with the On Hold on Loudspeaker feature.
Feature packaging
This feature is packaged under International Supplementary Features
(SUPP), package 131.
Feature implementation
Task summary list
The following task is required:
LD 15 – Activate Held Call Clearing in response to the HCC prompt to
implement this feature.