Instruction manual

Page 1602 of 3156 Group Hunt
553-3001-306 Standard 10.00 January 2002
Hunting is limited to the following:
• the total number of DNs in the group
• a maximum of 30 hunting groups for each hunting sequence (for multi-
group systems)
• a maximum of 18 hunting groups for each hunting sequence (for all other
systems)
Hunting may be limited to the total number of DNs in the group, or to a
maximum of 30 (for multi-group systems) or 18 (for all other systems)
hunting groups per hunting sequence.
A maximum of 31 digits can be entered in each list entry.
A maximum of 96 entries can be placed in each list.
A specific station can be defined within a group, among different groups, or
a combination thereof a maximum of 96 times.
A maximum of 8000 group hunt lists can be defined on a system
(programmable via the existing MSCL prompt in LD 17 and reduced by the
number of defined Speed Call and System Speed Call lists.)
For larger applications, the ACD package must be equipped to optimize call
control and call distribution.
It is recommended that the Group Hunt feature be primarily used with set-
associated DNs.
A group hunt pilot DN cannot be a member of its own list.
The round robin type of hunting should only be used if all entries in the group
hunt list are the same type (e.g., are all set-associated DNs or system-
associated DNs).
A Pilot DN may be accessed from a network TIE trunk. Also, members of the
Group Hunt list may be located at remote nodes.