Instruction manual

Group Hunt Page 1599 of 3156
Features and Services
Only one hunting type is allowed per group hunt list.
Linear:
Hunting starts at the first DN in the list and ends when one of the
conditions mentioned in “Termination conditions” on page 1596 is met.
Round Robin:
Hunting starts at the DN next in the list to the last DN that was hunted to.
Hunting ends when one of the conditions mentioned in “Termination
conditions” on page 1596 is met.
Group Hunt Lists
Group hunt lists are defined and modified via service change overlay
(LD 18). The Pilot DN entered for each list must have been previously
defined as a group hunt FFC in LD 57. When a group hunt list is defined, the
members are assigned a member number as in configuring a Speed Call List.
The maximum DN size of each member is 31 digits. The members in a list
can be one of the following:
• single or multiple appearance DN
• ACD-DN, VMS-DN, MC-DN, LDN, attendant DN
• route access code, route access code + number
• ESN access code + number, etc.
• group hunt Pilot DN, and
• members of another group hunt list.
Note: A group hunt list can also be modified via a Speed Call or System
Speed Call Controller key, via an analog (500/2500 type) telephone
feature Speed Call Controller, or via Group Hunting Speed Call or
System Speed Call Controller Flexible Feature Codes (FFC).