Instruction manual

Page 1596 of 3156 Group Hunt
553-3001-306 Standard 10.00 January 2002
• prevent group hunt termination on any idle member via a Group Hunt
Deactivate Flexible Feature Code (FFC) or via a GHD (Group Hunt
Deactivate) key
• limit the hunting steps to the total number of DNs in the list
• initiate hunting by dialing or accessing a group hunt Pilot DN directly,
and
• configure a DN to be a member of more than one hunt group.
Pilot DN
Pilot DNs are defined as PLDN Flexible Feature Codes (FFC) in LD 57.
Pilot DNs may be used in two ways:
1 If the USE prompt is set to GPHT, then the Pilot DN is defined to activate
Group Hunting.
2 If the USE prompt is set to SCLC (Speed Call List Controller) or SCLU
(Speed Call List User), then the Pilot DN is defined to access the Speed
Call or System Speed Call lists that are associated with the Pilot DN.
Termination conditions
When a group hunt Pilot DN is dialed, Group Hunting searches the list
associated with the Pilot DN, according to the hunt type specified, until one
of the following conditions is met:
1 an idle DN is encountered
2 an Automatic Call Distribution (ACD) DN,
Integrated Voice Messaging Service (VMS) DN,
Message Center (MC) DN,
Listed Directory Number (LDN),
or attendant DN is encountered
3 a route access code is encountered
4 ESN access code is encountered
5 a group hunt Pilot DN is encountered, or
6 all DNs in the group have been hunted to, or
the maximum number of hunting groups has been reached.