Instruction manual

Page 1584 of 3156 Generic XFCOT Software Support
553-3001-306 Standard 10.00 January 2002
LD 14 – This prompt is used to define a disconnect supervised loopstart trunk on an XFCOT. The
Periodic Pulse Metering parameters on a per country basis are defined in this overlay in response
to the PPID prompt.
Busy tone is provided by the PSTN when the far end releases from outgoing and incoming trunks.
The tone supervised COT depends on the busy tone frequency and cadence characteristic of the
particular country and is configured on a card basis by responding to the BTID prompt.
Prompt Response Description
REQ NEW New.
TYPE COT Central Office Trunk.
TN ll ss cc uu Terminal number of the unit; loop, shelf, card, and unit.
XTRK XCOT Ty pe is I PE COT.
CDEN (8D) Card density is 8D.
SIGL LOP Loop start signaling.
PPID xx Where xx is one of the following:
0 – United Kingdom (50 Hz)
1 – France (12 Khz)
2 – France (50 Hz)
3 – Germany, Egypt, Turkey, Venezuela, Indonesia, Finland
(16 Khz)
4 – Switzerland, Ireland, Portugal, Italy, Spain, Lebanon,
Tur key (12 Khz)
5 – Denmark (12 Khz)
6 – Norway, Belgium (16 Khz)
7 – Holland (50 Hz)
8 – Australia (two different packs) (12Khz/50 Hz)
9-15 – Reserved for future use.