Instruction manual

Page 1504 of 3156 Flexible Dial Tone Detection
553-3001-306 Standard 10.00 January 2002
This feature has the following three options:
Dial Tone Position (DTP)
With the DTP option an Outgoing Access Code (OAC) is selected. Then
FDTD verifies the dialed digits against the OAC (for example, country code)
of up to four digits. When DTP is set, only the OAC digits are outpulsed
before the DTD is reconnected. The DTP is the position immediately after the
OAC. Up to four OACs can be specified.
Count Detection (CNT)
With the CNT option, the system will send a pre-defined number of digits (up
to fifteen) before digit outpulsing is halted and the DTD is reconnected. Digit
counting is done either one digit at a time, or as a string if fast Tone and Digit
Switch (TDS) outpulsing is set up.
Digit Sequence (DGTS)
With the DGTS option, a table of up to 245 entries could be created of unique
one-to-four digit sequences where the DTD should be reconnected after.
Operating parameters
There are no operating parameters associated with this feature.
Feature interactions
There are no feature interactions associated with this feature.
Feature packaging
This feature is packaged under Dial Tone Detector (DTD) package 138.
Feature implementation
Task summary list
The following is a summary of the tasks in this section:
1 LD 16 – Set data for Flexible busy/overflow time:
2 LD 56 – Create tone and ringing parameters for one or more customers: