Instruction manual

Electronic Brandlining Page 1371 of 3156
Features and Services
In order for Option 11C and IODU/C customers to expand ISM limits, they
must order and install a new keycode. This installation is performed using the
Keycode Management feature. All Keycode Management commands are
executed in Overlay 143. To make the expansion effective, the customer must
sysload. For further information on keycode installation, please refer to
Software Conversion Procedures (553-2001-320).
For customers without Option 11C or IODU/C, ISM parameters are delivered
as per existing operation.
For further information on ISM, refer to the “Incremental Software
Management” on page 1725 in this book.
Custom Displays
The Electronic Brandlining feature provides the following two custom
displays:
• Terminal Text Broadcast Customized Text
• Default “NORTEL” or blank display
Terminal Text Broadcast Customized Text
When the Electronic Brandlining ISM parameter is equal to the Terminal
Text Broadcast value, the customized brandline to be displayed is initially
defaulted to NORTEL. This brandline can then be configured to display a
different customized brandline.
The customized brandline can have a maximum of 24 characters, each of
which must be supported by the North American Meridian Modular set
display firmware. Version 18 firmware supports 7-bit ASCII Roman
characters and 8-bit non-ASCII Roman characters (See Tables 42 and 43).
Alphanumeric and punctuation characters are supported.The customized
brandline is configured on a system basis (Overlay 17).
Figure 39 shows an example of a customized brandline displayed on the idle
screen of a Meridian Modular set.